Steelite Pressure Washers recall
Steelite Pressure Washers Recalled Due to Risk of Serious Injury or Death from Shock and Electrocution Hazards; Sold on Amazon by Longer 3D
- Published
- 26 Aug 2026
- Units affected
- About 128
- Agency
- CPSC
- Country
- United States

The hazard
The recalled pressure washers lack an integral ground-fault circuit-interrupter (GFCI) and an adequate-length power cord, posing a risk of serious injury or death from shock and electrocution hazards.
What to do
Consumers should stop using the recalled pressure washers immediately and contact Longer 3D for a full refund. Consumers will be asked to destroy the power washer by cutting the unplugged power cord in half and send a photo of the destroyed pressure washer to [email protected]. Consumers should then dispose of the destroyed recalled product. Refund
- Stop using the product until you have checked whether yours is affected.
- Compare model numbers, batch codes and dates on the label with the official notice.
- Contact the company in the notice for your refund, repair or replacement. Do not sell or give it away.
Product details
This recall involves Steelite-branded pressure washers. They are red and black and measure about 30 inches high, 10 inches wide and 12 inches deep. The 2.5 gpm, electric pressure washers have a foam cannon, four quick connect nozzles and a 20-foot hose. Model “AZ6041VC” is printed on a label on the back of the pressure washer.
Where it was sold and who to contact
Sold at: Sold Online At: Amazon.com from April 2026 through June 2026 for between $45 and $92.
Contact: Longer 3D by email at [email protected].
Source: U.S. Consumer Product Safety Commission, published 26 Aug 2026. CheckMyRecalls reproduces the official notice in summary; always confirm the details with the original notice.





